Forum Discussion
Kai_Wilke
Dec 21, 2016MVP
Hi
the
Error: Receive Timeout
error message is most likely caused by a malfunctioning Virtual Server / Pool / Node setup.
You may try to specify the provided IPs without any RD-suffixes (aka.
%0
). If this also fails, then change the IP of your Virtual Server so that you can access this IP:80 via your browser. If the browser can finally access the MGMT-UI then the iRule should be fine too.
ltm pool Pool_F5-MGMT-ETH {
members {
Node_F5-MGMT-ETH:https {
address 10.13.240.99
session monitor-enabled
state up
}
}
monitor gateway_icmp
}
ltm virtual VS_F5-MGMT-ETH {
destination 1.1.1.1:http
ip-protocol tcp
mask 255.255.255.255
pool Pool_F5-MGMT-ETH
profiles {
serverssl {
context serverside
}
tcp { }
}
source 0.0.0.0/0
source-address-translation {
type automap
}
translate-address enabled
translate-port enabled
}
Cheers, Kai