Forum Discussion

mschott_355664's avatar
mschott_355664
Icon for Nimbostratus rankNimbostratus
Dec 28, 2018

Deploy VE 13.1.1.2 VMware

Hello guys, I'm new in the F5 world and for study purposes, I'm deploying a VE appliance in the VMware, after doing the deploy I can't ping and access by web browser the F5. I set the correct VLAN in the interface but I noticed that the mgmt interface doesn't appear in the VMware, first I have configured the IP with the "config" command and the IP is placed in the mgmt interface. I had set up the IP also on the eth0 interface but without success. The question is, do I need to allow the access through the eth0 interface?

 

  • You have to allow tcp ports 22 and 443 in order to have access to the CLI and web GUI.

     

    HERE is a good source of information.

     

    Hope that helps! If it does please up-vote and select this answer, it'd be greatly appreciated!

     

    -Dylan

     

  • You have to allow tcp ports 22 and 443 in order to have access to the CLI and web GUI.

     

    HERE is a good source of information.

     

    Hope that helps! If it does please up-vote and select this answer, it'd be greatly appreciated!

     

    -Dylan

     

    • mschott_355664's avatar
      mschott_355664
      Icon for Nimbostratus rankNimbostratus

      Hi Dylan, yes, the 22 and 443 port are allowed. Another thing is that the LTM can't ping his gateway. Seems with a VLAN problem, but I checked and not found nothing wrong.

       

    • Dylan_375544's avatar
      Dylan_375544
      Icon for Cirrocumulus rankCirrocumulus

      Yeah it could be a VLAN problem, but I would start with checking your interfaces on VMware. You may have to configure your interfaces in VMware if you haven't. Also, read through that article as there is a plethora of helpful information in it.