After adding VLAN's or SELF IP all goes red
My network setup:
Webserver address:
- PV01 - 192.168.10.57
- PV02 - 192.168.10.58
Virtual IPs I would like to use
- ACD-PV01-VS-http 192.168.10.149
- ACD-PV01-VS-https 192.168.10.159
Management IP 192.168.110.147
When I create my Nodes, Pools and Virtual Servers all are Green
When I add the VLAN Group and Self IP all go Red
This is a fresh deployment what am I not doing correct?
VLAN Groups Setting:
- NamePV01-VLANG-01
- Partition / PathCommon
-
VLANs -- Two Choices I have tried both and none doesn't make a difference
- http-tunnel
- socks-tunnel
- Transparency ModeTranslucent
- Bridge All Traffic(UnChecked)
- Bridge In Standby(UnChecked)
- Migration Keepalive(UnChecked)
- Auto Last HopDefault
Created 2 Self IP's one for each IP assinged to the Source Address of the Virtual Servers
- NameACD-PV01-SIP-01 and ACD-PV01-SIP-02
- Partition / PathCommon
- IP Address192.168.10.149 and 192.168.10.159
- Netmask255.255.255.0
- VLAN / TunnelPV01-VLANG-01
- Port LockdownAllow ALL
- Traffic Group(UnChecked) Inherit traffic group from current partition / path
- Service PolicyNone
Webserver address: PV01 - 192.168.10.57 PV02 - 192.168.10.58
What ports?
Virtual IPs I would like to use ACD-PV01-VS-http 192.168.10.149 ACD-PV01-VS-https 192.168.10.159
You dont need the second as they are on different ports so you can just have them on port 80 and 443 on the same IP address.
Management IP 192.168.110.147
Yes thats good.
- Self IP's? These attach your BIGIP to the network at layer 3
- VLAN's? These attached your BIGIP to the network at layer 2
- Interfaces? These are your physical links for layer 1
Procedure
- Create VLAN using interface 1.1 (untagged if no VLAN)
- Create Self IP on new VLAN 192.168.10.10 (if not in use)
-
Create pool pool_webserver with the following new members
-
Create Virtual Server vs_webserver_443
-
Create Virtual Server vs_webserver_80
That should get you up and running but like the man said, do some training. You need to have a better idea of how all this works š