Forum Discussion
Sep 23, 2024
Hi mshoaib,
About your questions:
- Can we bring up new BigIP units (LB13 & LB14) using the 2 free CPUs on each i7800 unit? Yes it´s possible, this link shows you the Possible vCPU allocation per guest per slot/appliance https://my.f5.com/manage/s/article/K14218
- Can these new units join the existing HA pair of LB11 & LB12 and sync configuration to each other? Yes, it´s possible, but in the case of the fail of the nodes LB11 & LB12 with 6 CPUs, is possible new LB13 & LB14 in the traffic group can´t support the load with only 2 CPU.
- Can the new Units serve their own traffic groups ( as shown below in the diagram ) ? Yes, you can select the preferred device to run the traffic, and the failover order in case something fails.
- Is there any potential limitation or issue with utilizing the remaining CPUs for this purpose? No, the VCMP is a virtualization platform so you can use all the resources available, take in mind that the system has its exclusive CPUs to run the F5-VCMP system.
- Will i7800 run out of memory or go low in memory ?No, the same answer as the last one for this topic.
About your goals.
- Offload 20% of the traffic (a handful of VIPs) to the newly created LB13 & LB14 units. In my opinion is better if you deploy the new devices without introducing them to the existing traffic group, and then you can migrate the applications to these new devices.
- All LBxx ( 11,12,13 & 14 ) should back each other up and sync configuration across. As I mentioned, in the case of a failure in nodes 11,12, the load couldn´t be supported for nodes 13 and 14.
Hope it works.