network failover implementation

Hello Aaron,

 

 

Yes i have linked a cable from interface 1.8 on the active BIGIP to interface 1.8 on the standby BIGIP. I am getting errors relating to incorrect configurations when i am synching the two BIGIP's. I do have a question on this setup, when i configure the interface 1.8 dedicated for HA, it does not ask me for any IP Address. does the failover ip that i provide on the network failover section get mapped to the 1.8 interface? I have created a VLAN for 1.8 interface and named it as the HA_Heartbeat VLAN, but it still just a name. can we have a self IP Address just for the heartbeat Vlan with the same ip addresses as the failover ip addresses configured on the network failover section?

 

 

The trunk interfaces 1.1 and 1.2 (external vlan) of the active and standby BIGIPs are connected to a stacked switch (master and backup respectively)

 

 

Could you tell me what IP Address should i be giving in the config sync section? Is it the self ip address of the external vlan?

 

 

I have not yet configured an internal vlan and no floating ip addresses have been created. The internal vlan will be created at a later stage once the customer has its hosting infrastructure in place. Does this have any impact on the config synching of the bigips atleast for test purposes?

 

 

Thanks