Looking for Feedback on Configuring Network Mirroring/Failover for LTM v10.2.2
I have a pair of 3600s that are connected via serial cable and also have a directly connected network connection. Below is the current status of each of the High Availability features and what they use. My goal is to get everything going over the network. I used the article below as a reference and was just looking for some confirmation/feedback. Any reason to leave the serial cable in place or should I go this route?
Device 1 MGMT. 192.168.10.15
Device 2 MGMT. 192.168.10.16
Device 1 Direct Network Connection - 10.0.0.1
Device 2 Direct Network Connection - 10.0.0.2
Current
-Configsync
Device 1 Peer - 10.0.0.2
Device 2 Peer - 10.0.0.1
-Network Mirroring (Self-Peer; Primary Addr, Alternate Addr)
Device 1 - N/A, N/A
Device 2 - N/A, N/A
-Network Failover
Device 1 Peer Address - N/A
Device 2 Peer Address - N/A
Proposed
-Configsync
Device 1 Peer - 10.0.0.2
Device 2 Peer - 10.0.0.1
-Network Mirroring (Self-Peer; Primary Addr, Alternate Addr)
Device 1 - 10.0.0.1-10.0.0.2, 192.168.10.15-192.168.10.16
Device 2 - 10.0.0.2-10.0.0.1, 192.168.10.16-192.168.10.15
-Network Failover
Device 1 Peer Address - 192.168.10.16
Device 2 Peer Address - 192.168.10.15
I just wasn't sure if there was any reasons/thoughts on if it should be kept or removed.
i prefer keeping it because, as in askf5 sol, it provides faster failover response time.
Also wanted to make sure I was setting up the configuration correctly.
it looks okay to me. anyway, if you want, you may also add tmm self ip (in addition to mgmt ip) to network failover configuration.