Forum Discussion
7 Replies
Sort By
- Teerarat
Cirrus
Hi, if you can access cli try to using command config fo rconfiguration ip management l.
- Raghavendrachar
Nimbostratus
Can i set all interfaces as management -interface , so that i can access UI from any available network ? if so please share how to configure it - omniplex
Nimbostratus
Are you looking for Management::Device::set_management_address? - vishal_124938
Nimbostratus
Thanks a lot Steve. Updating Ip is my requirement. - What_Lies_Bene1
Cirrostratus
Apologies Vishal, I didn't spot you'd posted this in the iControl forum! Unfortunately I've no clue where iControl is concerned. Hopefully someone else can help you out here. - vishal_124938
Nimbostratus
Hi Steve, - What_Lies_Bene1
Cirrostratus
You can use these at the VMWare console to configure the management interface (eth0 in the CLI);